Re: Power supply

My machine isn't going to be that big. At the largest it would have a
cutting area of 12"X12"x3" . I'd think that the 12v, or 24+ of I
connected a few together would be more than enough. The steppers I
have are only 24v.

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "caudlet" <thom@...> wrote:
>
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, "krashking405"
> <krashking405@> wrote:
> >
> > I'm planning on using 1 or 2 computer PSUs to power my setup.
Planning
> > on using 1 just for the controllers, and 1 for the steppers. Any
> > suggestions?
> >
> Your machine will perform poorly and your rapids will be slow. You
> will need to learn to be patient. The highest voltage on a computer
> power supply is typically 12VDC.
>