Re: G201-IP

ditto !

I would not even ask twice if it was for a customer. I build in all
the protection I can.

too many circular saws are sold where the first project entails
cutting off the power cord.

Dave


--- In CAD_CAM_EDM_DRO@y..., "Carol & Jerry Jankura"
<jerry.jankura@s...> wrote:

> Interesting, as I'd take the tack of adding $15 per axis to my

quote and

> furnishing the protected drivers. Just before I retired, I was

involved in a

> similar situation (not using Gecko products) where my vendor made a

simple

> mistake that fried a $100 component (The project was costing us

somewhere in

> the high five figures). That mistake cost our vendor an extra

week's time,

> additional trips between Arizona (his base) and Ohio which would

have more

> than covered the $15.00 per axis that he'd have gladly spent had

the option

> been available to him.
>
> The point - Mariss, I think that your IP type boards have a place

and should

> sell if marketed properly.
>
>
> |P.S. to my last: I would opt for the G201/210 "AS-IS", rather

than pay an

> |additional $15 for "same thing plus protection". I would simply

be VERY

> |careful in the future, and SAVE the $$$!!!