Re: [CAD_CAM_EDM_DRO] Holding thin sheet

How about some sort of "vacuum plate" a kind of perf board with a vacuum
underneath?


At 10:01 AM 2/19/01, you wrote:

>I am trying to hold really thin stock ( plastic .060) and cut some small
>parts out of it. How do I hold this thin stuff.
>I am profiling with a .125 endmill.
>The parts will drop out so they have to be held after they are "free"
>and not get sucked into the cutter.
>What about double sided tape?
>How much of a cut can I take if I am holding with tape?

Bubba

OLDER THAN DIRT
Country Bubba
(Actually the inventor of Country and Bubba)

axtein@...
LaGrange, GA

[Non-text portions of this message have been removed]