Re: Holding thin sheet

>
> How about a small homemade vacuum table setup. Drill evenly spaced
> tiny holes in a sheet of "whatever? alum, Delrin etc"
>
> ===== =======|======= ======= ===|
> | |------->airflow >> ===== Vacuum source
> =================================|
>
> -Lee
>
> --- In CAD_CAM_EDM_DRO@y..., Joe Vicars <jvicars@c...> wrote:
> > I am trying to hold really thin stock ( plastic .060) and cut

> small
> > parts out of it. How do I hold this thin stuff.
> > I am profiling with a .125 endmill.
> > The parts will drop out so they have to be held after they
> are "free"
> > and not get sucked into the cutter.
> > What about double sided tape?
> > How much of a cut can I take if I am holding with tape?