Re: [CAD_CAM_EDM_DRO] Re: Software for wire EDM control?

At 15:14 30/07/2003 +0000, you wrote:

>Ok so Tcnc does 8 not 9 and there is more to wire than just moving
>each end of the wire BUT, is there anything to stop say Tcnc dealing
>with 4 axis code for x,y,u and v ??

From what I am hearing, you won't have any support in TNC for feedback
from the progress of the cut to control the motor speeds - backtracking
from shorts, controlling the wire to part gap to keep the current at the
optimum level, etc. So using TNC "as is"

Regards,
Tony