RE: [CAD_CAM_EDM_DRO] Gecko problems - What is going on?

Ron,

Thanks - what is the Z axis problem?

George



-----Original Message-----
From: Ron Kline [mailto:godsone@...]
Sent: Saturday, April 09, 2005 3:47 PM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: Re: [CAD_CAM_EDM_DRO] Gecko problems - What is going on?


Hi
I'll get a picture this evening .
Mine came from the factory with steppers and an ancient controller
called a Bandit , that I replaced with 3 Gecko 201 drives an Axxus
interface card and a 60 Volt 10 amp power supply controlled by Mach 2
and now Mach3 .
No problems except the Z axis drives .

Ron K