Re: [CAD_CAM_EDM_DRO] Re: Bridgeport Series I verse Series II CNC Refit Candidates

Quite right Jon, I was for some reason thinking back edge to front edge over
the travel, so if my memory of a table depth of 12" is actualy 15" then we
are spot on (It is six years ago). Same goes for the X travel, would have
been about 20 - 24" which explains why we had a hell of a job with that
expansion link (radius slot 64" Cord of slot 37", still have the drawing).

Dave M.

----- Original Message -----
From: "Jon Elson" <elson@...>
Subject: Re: [CAD_CAM_EDM_DRO] Re: Bridgeport Series I verse Series II CNC
Refit Candidates


>>
> No, no, not THIRTY inches of Y travel. That would have required a
> knee sticking 5 feet out of the column. The Y travel of the Series-II
> is 15", which is actually quite a lot of Y motion!
>
> Jon



--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.362 / Virus Database: 267.12.8/161 - Release Date: 03/11/2005