Re: My 3D printer software done

P.S. The document isn't right. Its close but no cigar.

After the reserved field there may or may not be 2 flots thown in. No
idea what they are or how to predict. Question has been asked of
Rhino. The only solution seems to be try it and if it looks goofy try
with the floats.

Clockwise/counter clockwise for inside/outside of boundries is not
right. The contour sets the outside direction, the boundry is inside
if it is opposit of the contour.

Boundries only have the last two fields of the contour header.

There are probably more that I have just forgotton or haven't stumbled
across yet.

If I ever get access to the files area I will post the program that
converts the SLC file to a readable ASCII. Graham is currently my
brave guinea pig. I've taken apart my HP printer and am facing a pile
of pieces trying to figure out exactly how I am going to put all theis
back together as a flatbead printer.

Via Con Dios,
Roger

> http://rpdrc.ic.polyu.edu.hk/old_files/slc_introduction.htm