Re: [CAD_CAM_EDM_DRO] mach3 question

Chuck,
 
Go to Artsoft's site and run through the tutorials on set up of Mach3.   It will get you up to speed on the set up.  Also go to the Mach3 forums.
 
You need to go to the config to reset the direction to active high or low as the case may be.
 
Jack

--- On Fri, 12/4/09, ebiz_59 <chuckm@...> wrote:


From: ebiz_59 <chuckm@...>
Subject: [CAD_CAM_EDM_DRO] mach3 question
To: CAD_CAM_EDM_DRO@yahoogroups.com
Date: Friday, December 4, 2009, 11:11 AM


 



Our science and tech club finally got a used minimill (X2) with cnc and Xylotec controller running using Mach3. Woohoo, we have entered the 21st century! One issue we are having though is that when running the mill using Mach3 and the computer keyboard, the key directions seem to be reversed. Where did we mess up in setup? Is that in the configuration of pins setup?? This is all new to us and way cool to actually see something move, but then we realized XY and ?Z? were all moving opposite the direction of the arrow keys - took a little wind out of our sails. thanks, Chuck











[Non-text portions of this message have been removed]