RE: [CAD_CAM_EDM_DRO] OT: Intro + Q:Selecting workshop heater

The heaters I am looking at all vent the combustion products out doors. So,
the heating has a drying effect and no additional moisture is added to the
indoor air. In Colorado rust is not a major problem. I agree that using a
non vented heater is a dicey proposition. Besides the moisture there are
concerns about the CO2 and CO buildup.

Tim
[Denver, CO]

> Hi,
>
> The problem with workshop heating is rust. If you can sort out a
> remote heat
> source and pipe dry air into the shop this is the ideal. The fuels you are
> thinking about using are almost all water and that is released into the
> atmosphere of your shop.
>
> Terry
>
> >I'm converting my garage to a workshop, but
> > it's pretty darned cold in there. I want to get a little Propane or
> > Kerosene heater, but don't really know what's the better choice. If
> > anyone has any opinions on the matter, I'd appreciate hearing them.
> >
> > Thanks...
> >
> > --marco
>
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for
> the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>