RE: [CAD_CAM_EDM_DRO] Re: Can CNCPro users provide some input?

Nothing similar to EMC that I am aware of other than some of the commercial
($$$$) controllers.

If you are selling it to customers and installing it for them then you don't
have to get involved with the fact it is Linux. It is just a machine
controller that happens to be capable of networking with their Windows
machines for file transfers. It would not be very hard to make it boot up,
logon and immediately start an EMC session. Will look just like a
proprietary controller and no one has to know it is Linux. Now if you want
them to install and setup themselves, this is another story.

Tim
[Denver, CO]

> -----Original Message-----
> From: cnc002@... [mailto:cnc002@...]
> Sent: Monday, March 19, 2001 9:32 AM
> To: CAD_CAM_EDM_DRO@yahoogroups.com
> Subject: Re: [CAD_CAM_EDM_DRO] Re: Can CNCPro users provide
> some input?
>
>
> Tim:
>
> EMC looks great but none of my customers want to use Linux
> when DOS or
> Windows NT works for them and they are familiar with those.
> Is there any
> other software out there like EMC but that runs in either DOS
> or WinNT? I
> have been looking but can't find it.
>
> Regards,
>
> Randy Abernathy
> Woodworking Machine Specialist
> 4626 Old Stilesboro Road NW
> Acworth, GA 30101-4066
> Phone/Fax: 770-974-5295
> E-mail: cnc002@...
>
>
> [Non-text portions of this message have been removed]
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list
> for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@...
> [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to
> http://docs.yahoo.com/info/terms/
>
>
>