Re: 2 Fried G210's in a single day :-(

--- In CAD_CAM_EDM_DRO@y..., "audiomaker2000" <audiomaker@s...> wrote:

> I also learned that when you use only 4 wires of a 6 wire motor,
> that you are in essence changing it from a parallel configuration

to

> a series and need to limit the current. My understanding was that
> the motor was rated at 8 amps from the factory, and that it was
> series wired from the factory, meaning that it would require 8 amps
> in the state it was in unless I *changed* the wiring so I didn't
> have any current resistor in there....mistake. Not connecting

those

> two extra wires put my current needs at 4 amps.

A 8-wire stepper motor was given as 2.1 Amp 2.4 ohm. for connection
in parallel. Would this mean that its rated voltage would be about
5V ?

So what will be its rating if it is connected in series?

4.2Amp and 2.5 volt?

keongsan