Re: Encoder Indexer Option

Sorry. Click R9xH from the link I posted then
click on SetUp & Tune. Their website is full of
good setup and tuning info.

BTW they have software on their website to tune their
servo's. Has anyone used it? Just wanted to know if
it may be an advantage to buying a Rutex over a Gecko.

Scott





--- In CAD_CAM_EDM_DRO@yahoogroups.com, Stephen Wille Padnos
<spadnos@s...> wrote:

> Polaraligned wrote:
>
> >I don't know about the one you spec'd out. I did not look
> >yours up. Diff encoders have an inverted output also for each channel.
> >
> >Check this out.
> >
> >http://www.rutex.com/home/index
> >
> >Go to bottom of page and download whole pdf document.
> >
> >It is a great source of info on setting up a servo system
> >using rutex hardware. It gives lots of encoder interfacing
> >info. Using diff encoders may save a headache. So if the
> >cost is small, which it should be, why not use them?
> >
> >Scott
> >
> >
> I think they changed their website around recently - there's no PDF
> linked at the bottom of the page :)
> You might want to put in the name of the file you were suggesting, or a
> direct link to it.
>
> - Steve