Re: [CAD_CAM_EDM_DRO] DeskNC Windows version

>Actually I did see your post and that is what got me interested. Was
>wondering if anyone else on the list had decided to give it a try.
>
>Looking at the naming convention of the support files and the supported
>g-code I would guess that DeskNC for Windows is using some of the EMC files
>as it's code base. Do you know if this is a fact?
>
>Tim
>[Denver, CO]
>
>> You must not have seen my post a few weeks ago about the DeskNC
>> for windows.
>> The black box works slick. On the old DeskNC for dos I could get
>> about 3000
>> sps per second out of my 5A driver. With the black box and a little bit

>> tuning I got the same driver and same stepper motor running at 9500 steps
>> per second . It was really smooth. I was impressed. I also tested
>> it with a
>> G320 and it too ran great. The only current problems are :
>> 1. no backlash compensation,
>> 2. constant contouring isn't finished.
>> 3. really odd pin out from his db25 that requires a breakout box.
>> Otherwise it looks and runs very well.
>> Dan
>> >
>> >FAQ: http://www.ktmarketing.com/faq.html
>>
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@yahoogroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
>List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
>Moderator: jmelson@... timg@... [Moderator]
>URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>bill,
>List Manager
>
>FAQ: http://www.ktmarketing.com/faq.html
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>