RE: [CAD_CAM_EDM_DRO] Re: FS: X-Y Table

Hello Mariss,

Yes it is pin 7 and it is on a MD-10A.

Got to see the Series II Bridgeport I purchased on E-Bay back in September
today. It got to the rigging company last Thursday and today is the first
chance I had to drive out and take a look. You are right, those finned
stepper really are ugly. Still not quite sure what I am going to do for
drives. Trying to figure out if it would be worth while to remove the
steppers and bolt on some servo motors and drive them with a set of G320's.
If you had the high voltage stepper drives available I would just bolt them
on and be done with it. Don't know if I would be happy with the rapid rates
I would get with G2XX drives.


Tim
[Denver, CO]

> -----Original Message-----
> From: mariss92705@... [mailto:mariss92705@...]
> Sent: Tuesday, April 17, 2001 10:07 PM
> To: CAD_CAM_EDM_DRO@yahoogroups.com
> Subject: [CAD_CAM_EDM_DRO] Re: FS: X-Y Table
>
>
> Tim,
>
> Good evening! Which terminal number? They private-labeled the drive
> we called the CN0143 and I don't recall their nomenclature. Otherwise
> the terminal assignment is the same as the G201 except terminal 7 was
> a "no connection".
>
> They also private-labeled several other of my designs so I may be
> able to lookup the pinouts for them as well if what you have is not
> the MD-10.
>
> Mariss
>
>
> --- In CAD_CAM_EDM_DRO@y..., "Tim Goldstein" <timg@k...> wrote:
> > Great, now I can find out the answer that Oregon Microsystems could
> not
> > answer (and was pretty snotty that I would even ask for info on an
> old
> > drive).
> >
> > What does the pin marked Control do?
> >
> > Tim
> > [Denver, CO]
> >
> > > Hi,
> > >
> > > You really should run the Oregon Microsystems (MD-10 I believe)
> > > drives between 24VDC to 60VDC. I designed them.
> > >
> > > Mariss
> > > FAQ: http://www.ktmarketing.com/faq.html
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for
> the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>