Re: [CAD_CAM_EDM_DRO] machine ways was Re: Motor vs. Servo

----- Original Message -----
From: "Smoke" <smoke@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Saturday, December 29, 2001 12:45 PM
Subject: Re: [CAD_CAM_EDM_DRO] machine ways was Re: Motor vs. Servo


> And just to confuse the issue some more:
>
> "Ways" upon which part slide when used in a transfer machine are usually
> referred to as "rails".
>
> Sometimes "ways" made from round shafting use solid bushings instead of
ball
> bearing units. Purists might say that the round "ways" are more properly
> called guide bars, irregardless of the type of bearings used.
>
> Yes, Ballendo, I do believe we are a'way's from where we started. :)
>
> Smoke
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>