Re: [CAD_CAM_EDM_DRO] machine ways was Re: Motor vs. Servo

Yo Sven;

I can agree with that, as shown, but what about with dual/multiple dovetails?

Also, what about accuracy/longevity/other factors? The roundway roller bearing
guides do have fairly large speed/weight bearing numbers, so what I'm thinking
here, is that this sort of setup might have better wear factor in the bottom
adjustment department. Is there a better means of adjustment that is standard
for dovetails?

Would it make a better milling table if just using the roundway/rail setup
alone? Wondering about using paired dual roundsways pressed to the rail from
the sides in a sort of, "X", configuration there.....

Bill

On Sun Dec 30 04:25:23 2001, Sven Peter, <peteryco@...> wrote:

>>Hello Bill,
>At some point your set up will start to tilt.
>Sven Peter
>
>Bill Vance wrote:
>>
>> Sort of, using their dovetail setup, but backing it up differently. Consider
>> the following:
>>
>> ________________________________________
>> | |
>> | table |
>> |__________________ _______________|
>> ________________ / \ _____________
>> // \\
>> base // \\ base
>> //_____________\\
>> / |__ __| \
>> \ /
>> ,O.
>> __//_\\__
>> |_________|
>>
>>

--
----------------------------------------------------------------------------
RKBA! ***** Blessings On Thee, Oh Israel! ***** 4-19!
----------------+----------+--------------------------+---------------------
An _EFFECTIVE_ | Insured | All matter is vibration. | Let he who hath no
weapon in every | by COLT; | -- Max Plank | weapon sell his
hand = Freedom | DIAL | In the beginning was the | garment and buy a
on every side! | 1911-A1. | word. -- The Bible | sword.--Jesus Christ
----------------+----------+--------------------------+---------------------

Constitutional Government is dead, LONG LIVE THE CONSTITUTION!!!!!

----------------------------------------------------------------------------